User guide
Canopy System User Guide Configuring a Point-to-Multipoint Link for
Test
pmp-0229 (Mar 2013)
211
Region Code
From the drop-down list, select the region in which the radio is operating.
When the appropriate region is selected in this parameter, the radio automatically implements the
applicable required Dynamic Frequency Selection (DFS) standard. For further information on
DFS, see Radar Signature Detection and Shutdown on Page 127.
The slave radio automatically inherits the DFS type of the master. This behavior ignores the value
of the Region Code parameter in the slave, even when the value is None. Nevertheless, since
future system software releases may read the value in order to configure some other region-
sensitive feature(s), you should always set the value that corresponds to the local region.
Unlike selections in other parameters, your Region Code selection requires a Save Changes and a
Reboot cycle before it will force the context-sensitive GUI to display related options (for
example, Alternate Frequency Carrier 1 and 2 in the Configuration => Radio tab). Thus, a
proper configuration exercise in environments that are subject to DFS requirements has two
imperative Save Changes and Reboot cycles: one after the Region Code is set, and a second after
related options are set.
Site Name
This field indicates the name of the physical module. You can assign or change this name in the
SNMP tab of the SM Configuration page. This information is also set into the sysName SNMP
MIB-II object and can be polled by an SNMP management server.
Site Contact
This field indicates contact information for the physical module. You can provide or change this
information in the SNMP tab of the SM Configuration page. This information is also set into the
sysName SNMP MIB-II object and can be polled by an SNMP management server.
Site Location
This field indicates site information for the physical module. You can provide or change this
information in the SNMP tab of the SM Configuration page.
Maximum Throughput
This field indicates the limit of aggregate throughput for the SM and is based on the default
(factory) limit of the SM and any floating license that is currently assigned to it.
MP Double Rate
This field indicates whether 2X modulation rate is enabled for the sector.