User guide
Configuring a Point-to-
Multipoint Link for Te
Testing the Components
206
pmp-0229 (Mar 2013)
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.
Low Priority Downlink CIR
This field displays the value that is currently in effect for the SM, with the source of that value in
parentheses. The configuration source of the value is indicated in parentheses. See
• Committed Information Rate on Page 85
• Setting the Configuration Source on Page 324.
Rate
This field displays whether the high-priority channel is enabled in the SM and the status of 1X or
2X operation in the SM. See Checking the Status of 2X Operation on Page 91.
Beginning the Test of Point-to-Multipoint Links
To begin the test of links, perform the following steps:
1. In the Session Status tab of the AP, note the LUID associated with the MAC
address of any SM you wish to involve in the test.
2. Click the Remote Subscribers tab.
Remote Subscribers Tab of the AP
An example of a Remote Subscribers tab is displayed in Figure 68.
Figure 68: Remote Subscribers tab of AP, example
This tab allows you to view the web pages of registered SMs over the RF link. To view the pages
for a selected SM, click its link. The General Status tab of the SM opens.