User guide

Canopy System User Guide Configuring a Point-to-Multipoint Link for
Test
pmp-0229 (Mar 2013)
203
MAC
This field displays the MAC address (or electronic serial number) of the SM. Both the LUID and
the MAC are hot links to open the interface to the SM. In some instances, depending on network
activity and network design, this route to the interface yields a blank web page. If this occurs,
refresh your browser view.
State
This field displays the current status of the SM as either
• IN SESSION to indicate that the SM is currently registered to the AP.
• IDLE to indicate that the SM was registered to the AP at one time, but now is not.
This field also indicates whether the encryption scheme in the module is enabled.
Site Name
This field indicates the name of the SM. You can assign or change this name on the Configuration
web page of the SM. This information is also set into the sysName SNMP MIB-II object and can
be polled by an SNMP management server.
Software Version
This field displays the software release that operates on the SM, the release date and time of the
software.
FPGA Version
This field displays the version of FPGA that runs on the SM.
Session Timeout
This field displays the timeout in seconds for management sessions via HTTP, telnet, or ftp access
to the SM. 0 indicates that no limit is imposed.
AirDelay
This field displays the distance of the SM from the AP. To derive the distance in meters, multiply
the displayed number by 0.3048. At close distances, the value in this field is unreliable.
Session Count
This field displays how many sessions the SM has had with the AP. Typically, this is the sum of
Reg Count and Re-Reg Count. However, the result of internal calculation may display here as a
value that slightly differs from the sum.