User guide

Canopy System User Guide Configuring a Point-to-Multipoint Link for
Test
pmp-0229 (Mar 2013)
201
Figure 67: Session Status tab data from AP, example
If no SMs are registered to this AP, then the Session Status tab displays the simple message No
sessions. In this case, try the following steps.
Procedure 9: Retrying to establish a point-to-multipoint link
1. More finely aim the SM or SMs toward the AP.
2. Recheck the Session Status tab of the AP for the presence of LUIDs.
3. If still no LUIDs are reported on the Session Status tab, click the Configuration
button on the left side of the Home page.
RESULT: The AP responds by opening the AP Configuration page.
4. Click the Radio tab.
5. Find the Color Code parameter and note the setting.
6. In the same sequence as you did for the AP directly under Configuring a Point-to-
Multipoint Link for Test on Page 190, connect the SM to a computing device and
to power.
7. On the left side of the SM Home page, click the Configuration button.
RESULT: The Configuration page of the SM opens.
8. Click the Radio tab.