User guide

Configuring a Point-to-
Multipoint Link for Te
Testing the Components
200
pmp-0229 (Mar 2013)
WARNING!
From this point until you remove power from the SM, stay at least as far from the
SM as the minimum separation distance specified in
Table 43 on Page 174.
5. Plug the power supply into an electrical outlet.
6. Repeat the foregoing steps for each SM that you wish to include in the test.
7. Back at the computing device, on the left side of the Time & Date tab, click
Home.
8. Click the Session Status tab.
Session Status Tab of the AP
An example of the AP Session Status tab is displayed in Figure 67.