User guide

Configuring a Point-to-
Multipoint Link for Te
Testing the Components
198
pmp-0229 (Mar 2013)
10. Ensure that the initial parameters for the AP are set as you intended.
11. Click the Save Changes button.
12. Click the Reboot button.
RESULT: The AP responds with the message Reboot Has Been Initiated…
13. Wait until the indicator LEDs are not red.
14. Trigger your browser to refresh the page until the AP redisplays the General
Status tab.
15. Wait until the red indicator LEDs are not lit.
Time Tab of the AP
To proceed with the test setup, click the Configuration link on the left side of the General Status
tab. When the AP responds by opening the Configuration page to the General tab, click the Time
tab. An example of this tab is displayed in Figure 66.
Figure 66: Time tab of AP, example