User guide
Configuring a Point-to-
Multipoint Link for Te
Testing the Components
192
pmp-0229 (Mar 2013)
Quick Start is a wizard that helps you to perform a basic configuration that places an AP into
service. Only the following parameters must be configured:
• Region Code
• RF Carrier Frequency
• Synchronization
• LAN (Network) IP Address
In each Quick Start tab, you can
• specify the settings to satisfy the requirements of the network.
• review the configuration selected.
• save the configuration to non-volatile memory.
Proceed with the test setup as follows.
Procedure 7: Using Quick Start to configure a standalone AP for test
1. At the bottom of the Quick Start tab, click the Go To Next Page => button.
RESULT: The AP responds by opening the Region Settings tab. An example of
this tab is shown in Figure 61.
Figure 61: Region Settings tab of AP, example
2. From the pull-down menu, select the region in which the AP will operate.