User guide

Canopy System User Guide Configuring a Point-to-Multipoint Link for
Test
pmp-0229 (Mar 2013)
191
In the address bar of your browser, enter the IP address of the AP. (For example, enter
http://169.254.1.1 to access the AP through its default IP address). The AP responds by
opening the General Status tab of its Home page.
Quick Start Page of the AP
To proceed with the test setup, click the Quick Start button on the left side of the General Status
tab. The AP responds by opening the Quick Start page. The Quick Start tab of that page is
displayed in Figure 60.
NOTE:
If you cannot find the IP address of the AP, see Override Plug on Page 59.
Figure 60: Quick Start tab of AP, example