User guide

Canopy System User Guide Viewing Typical Layouts
pmp-0229 (Mar 2013)
111
Time Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Time and Date from CMM via Network Time
Protocol (NTP) server
AP BHM Configuration/Time yes
Time and Date manually settable AP BHM Configuration/Time yes
CMM provides NTP server
CMMmicro
CMM4
no no
Spectrum Analyzer Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Spectrum analyzer SM BHS Tools/Spectrum Analyzer no
Ability to switch an AP to an SM (or BHS to
BHM)
AP BHM Configuration/General yes
Remote Spectrum Analysis AP Tools/Remote Spectrum Analyzer no
Aim/Link Quality Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Alignment tone for using during
aiming/alignment
SM BHS no no
Aiming support page when not using
alignment tone
SM BHS Tools/Alignment
multiple
objects
LED for alignment SM BHS no no
Configure SM power-up state - aiming or
operational
SM BHS Configuration/General yes
Link capacity test, with configurable packet
length
All radios Tools/Link Capacity Test yes
Display of SM configuration information at
AP
AP BHM Home/Session Status yes
Display/evaluation of AP beacon data from
all receivable APs
SM BHS Tools/AP Evaluation yes
Over-the-air radio Bit Error Rate (BER)
indicator
SM Tools/BER Results yes
Graphical alignment tool with near-real time
jitter and received power level
SM Tools/Alignment Tool no
Optional selection of Revised or Legacy LED
indicator scheme
SM Configuration/Unit Settings no
Frame Tool Feature
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Frame calculator for supporting co-location All radios Tools/Frame Calculator no