User guide

Canopy System User Guide
pmp-0229 (Mar 2013)
104
Chapter 10: Accessing Features
PMP 100 and 400 and PTP 100 and 200 Series radios support the features that are indicated in
Table 26.
Table 26: List of features
Regulatory Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
RoHS compliant (EU “green” mandate) All modules no no
WEEE compliant All modules no no
Complies with Human RF exposure limits
(ETSI)
All radios no no
Radio Features
Module
Type(s) Controlled in GUI Page/Tab
SNMP
Control
Time Division Duplex All radios no no
Scalable up to 6 sectors per cell. AP SM no no
200 registered subscribers supported per AP AP SM no no
Fixed/nomadic operation All radios no no
7 ms or less round trip latency (OTA under
normal conditions)
All radios no no
Transmit frame spreading for geographical
area co-existence
AP BHM Configuration/Radio yes
Radio statistics (scheduler) All radios Statistics/Scheduler yes
2X rate, enabled per link (requires CAP 130,
CAP 09130, or 20 Mbps BH)
SM BHS Configuration/General yes
2X rate, enabled per sector (requires
CAP 130, CAP 09130, or 20 Mbps BH)
AP BHM Configuration/General yes
Manual transmit power control - normal and
low (-18 dB)
All radios Configuration/Radio yes
Manual transmit power control, 1 dB
increments over 25 dB at the AP
AP BHM Configuration/Radio yes
SM Transmit Power Control (Automatic SM
Transmit Power Adjustment)
AP BHM Configuration/Radio yes
SM Receive Target Level AP BHM Configuration/Radio yes