User guide

Release9.5ReleaseNotes



Issue2,October2009  Page61
5440 SM
5440 BH
17 dBi integrated
antenna (15° x
15° -3 dB beam
width)
10 dBm
ABZ89FT7631 109W-4940 10 MHz channels,
centered on 4945-
4985 in 5 MHz
increments (within the
4940-4990 MHz
public safety licensed
band)
4940 AP
18 dBi
connectorized
PCTEL Model AP
85010066001
antenna (60° x 5°
-3 dB beam width)
with 1 dB cable
loss
18 dBm
4940 SM
4940 BH
17 dBi integrated
antenna (15.5° x
17.5° (el x az) -3
dB beam width)
18 dBm
Note 1: To ensure regulatory compliance, including DFS compliance, the professional installer is responsible
for
◦ setting the Region Code on the Configuration => General page to the correct region
◦ setting the Transmitter Output Power on the Confiiguration => Radio page no higher than listed for a
given configuration
setting the External Gain on the Configuration => Radio page, if displayed, to the gain of any external device
(such as a reflector or lens)
10.2.2 IndustryCanada(IC)Notification
For 900-MHz, 2.4-GHz, 5.2-GHz. 5.4-GHz, and 5.7-GHz devices:
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Users should be cautioned to take note that in Canada high power radars are allocated as primary users
(meaning they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz and these radars could cause
interference and/or damage to license-exempt local area networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
RSS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio-frequency
energy and, if not installed and used in accordance with these instructions, may cause harmful interference
to radio communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is encouraged to correct
the interference by one or more of the following measures:
 Increase the separation between the affected equipment and the unit;
 Connect the affected equipment to a power outlet on a different circuit from that which
the receiver is connected to;
 Consult the dealer and/or experienced radio/TV technician for help.
To reduce potential radio interference to other users, the antenna type and its gain should be chosen so its
Equivalent Isotropic Radiated Power (EIRP) is not more than that permitted for successful communication.
Industry Canada Certification Numbers and the specific configurations covered are listed in Table 13.
This device has been designed to operate with the antennas listed in Table 13 and having a maximum gain
as shown in Table 13. Antennas not included or having a gain greater than as shown in Table 13 are strictly
prohibited from use with this device. Required antenna impedance is 50 ohms.