User guide

Release9.5ReleaseNotes



Issue2,October2009  Page15
2.3.1 USRegionCodeforUS5.x‐GHzAPs
A 5.2-, 5.4-, or 5.7-GHz P10 or higher AP or BH with a Region Code set to United States and
upgraded to Release 9.5 will continue to be set to the United States Region Code and will not
be configurable to another Region Code by installers or end users. As discussed in section 2.3,
this is in response to FCC KDB 594280 and ensures that end users and professional installers
will not have access to settings which could allow a radio to be configured to operate in a manner
other than that which was specified in the FCC equipment authorization grant.
After upgrade, the AP or BH will display the Region Code on the Configuration => General page
as United States in a gray font, and the parameter is no longer settable, as shown in Figure 4.
Figure 4: Configuration => General page with Region set to United States