User guide

Release9.5ReleaseNotes



Issue2,October2009  Page10
1.5 IDENTIFYINGHARDWARESERIES(P7,P8,P9,P10,P11)
The following methods can be used to identify the hardware series of a module:
 For modules that are running Release 8 or Release 9, look on the Home => General
Status tab, under Board Type as shown in Figure 1.
Figure 1: Board Type on modules running Release 8.
 For modules that are running Release 7.3.6, view the Configuration web page.
◦ If a Scheduling option is present, as shown in Figure 2 below, then the
hardware series is P9.
Figure 2: Scheduling option – if viewable, indicates this is a P9 Board.
◦ If no Scheduling option is present, then the series is either P7 or P8.
 For modules running any release, open a telnet interface to the module and
enter version. The hardware series is shown under Hardware Platform as 7, 8,
9, 10, or 11.
Figure 3: Telnet – Version showing hardware platform.
1.6 DOCUMENTCHANGEHISTORY

Issue 1a First Issue
Issue 2 Addition to Section 4: Known open issue: SM – DNS below a NATed
SM