Specifications

- Send data - Set to transfer the captured data to the foreground application. Disabling this option prevents the
actual data from being transmitted. However, the prefix and suffix strings, if present, are still transmitted even
when this option is disabled (default - enabled).
- Send as hex - Set to send the data in hexadecimal format. A check in the checkbox indicates that the plug-in is
enabled (default - disabled).
- Send TAB key - Set to append a tab character to the end of the processed data. A check in the checkbox
indicates that the plug-in is enabled (default - disabled).
- Send ENTER key - Set to append an Enter character to the end of the processed data. A check in the
checkbox indicates that the plug-in is enabled (default - disabled).
Usage
This section provides information on how to configure IP Output using the DataWedge configuration user interface.
To use IP Output in a particular DataWedge profile (for example: Profile0), scroll downward on IP Output.
Figure 61: IP Output Screen
Using IP Output with IPWedge
IPWedge is a computer application that can be easily configured to retrieve data sent over network by DataWedge IP
Output. Refer to the IPWedge User Manual on how to install and configure in a host computer. To enable IP Output
to send captured data to a remote computer that is installed with IPWedge:
Procedure:
1 In IP Output, touch Enabled.
A check appears in the checkbox.
2 Ensure Remote Wedge option is enabled.
3 Touch Protocol.
4 In the Choose protocol dialog box, touch the same protocol selected for the IPWedge computer application.
(TCP is the default).
DataWedge Configuration | 73
MN000887A01 | June 2014 | Send Feedback