User guide

244

• The

-c

count

argument lets you specify the number of ICMP packets generated for the

ping request. Values greater than 250 are truncated to 250.

You can use the ping command to determine whether a hostname or IP address is

already in use on your network. You cannot use the ping command to ping the Netopia

Gateway’s own IP address.

quit

Exits the Netopia Gateway command line interface.

reset arp

Clears the Address Resolution Protocol (ARP) cache on your unit.

reset atm

Resets the Asynchronous Transfer Mode (ATM) statistics.

reset cdmode

This command will set up one boot ﬂag so that next time a 3342N/3352N restarts or

reboots (power cycle), the Gateway will boot into CD-ROM mode instead of Gateway mode.

This command is only for 3342N/3352N. It checks if the platform is 3342N/3352N or

not. If the Gateway is not a 3342N/3352N this command does nothing but returns the

message: "CD mode is not supported on this platform."

reset crash

Clears crash-dump information, which identiﬁes the contents of the Netopia Gateway regis-

ters at the point of system malfunction.

reset dhcp server

Clears the DHCP lease table in the Netopia Gateway.