User guide

123
Configure
the other with uplink and eth0.3.
7. Once you have finished with the configuration of the VLANs, click on the
Alert icon in the upper right hand corner.
This will validate that the settings are legal for your network.
8. Click the
Save and Restart
link.
This will restart the Netopia Gateway and retain the VLAN configuration.
Note:
To make a set of VLANs non-routable, the uplink port must be included in at
least one VLAN. It must then be excluded from any VLANs that are non-
routable. The VLANs that have this excluded will not only be prevented from
accessing the Gateway the Internet, they will not obtain an IP address through
DHCP on the Gateway. If you want to allow them these privileges, the uplink
option will need to be selected.
By default if the vcc1 option (in this case PPP over Ethernet VCC1) is not
added to any VLAN, all users will be able to access the Internet, unless uplink
has been disabled. If you add the vcc1 interface to a VLAN, only that VLAN
will be able to access the Internet, while the rest will be restricted.