Brukerveiledning
Table Of Contents
- Exhibit D - Tune-Up Procedure-User Manual-front
- Pages from MN003557A01-AL_enus_SLR1000_Repeater_Basic_Service_and_Installation_Manual_NAG
- Pages from Exhibit D - Tune-Up Procedure-User Manual-d2header
- MN003581A01_AA_enus_MOTOTRBO_SLR_1000_Repeater_Quick_Start_Guide-modified
Chapter 8
SLR 1000 Programming and Tuning
8.1
Programming and Tuning Introduction
This section provides an overview of the MOTOTRBO Radio Management (RM) and the MOTOTRBO
Tuner application for use on Windows 7, Windows 8, or Windows 8.1. These two MOTOTRBO
applications are used for the configuration and alignment of the SLR 1000 Repeater .
8.2
Radio Management Setup
The Radio Management (RM) is used to program the SLR 1000 Repeater.
See Figure 20: Radio Management Setup on page 64 and Figure 11: SLR 1000 Repeater
Transceiver Board Connector Locations on page 45 for the connectors on the repeater.
NOTE: See the Radio Management (RM) Online Help for the programming procedures.
CAUTION: Computer USB ports can be sensitive to Electronic Discharge. Use proper ESD
practices (wrist strap, grounding, and so on.) and do not touch exposed contacts on cables
when connected to a computer.
Figure 20: Radio Management Setup
Station
Bottom Panel
13.6 V DC
8.3
Repeater Tuning Setup
A personal computer (PC) with a Windows operating system, and the MOTOTRBO Tuner application
are required to align the SLR 1000 Repeater. To perform the tuning procedures, the repeater must be
connected to the PC and the test equipment setup as shown in Figure 21: SLR 1000 Repeater Tuning
MN003557A01-AL
Chapter 8 : SLR 1000 Programming and Tuning
64
Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Tune-Up Procedure
Exhibit D1 1 of 11