Brukerveiledning

11
English
Post-Installation Checklist
Applying Power
After the SLR 1000 Repeater has been mechanically installed and all
electrical connections have been made, power may now be applied
and the repeater checked for proper operation.
Front Panel LEDs
After turning on the repeater power, the three LEDs on the repeater
cover:
• Light for approximately one second to indicate that they are
functional, then
• Go off for one second, then
• Indicate the operational status of the repeater.
Verifying Proper Operation
Operation of the repeater can be verified by:
• Observing the state of the three LEDs located on the front panel,
and
• Exercising radio operation.
Archiving
Copying the Repeater Codeplug Data to a Computer
Proceed to the Radio Management (RM) configuration procedures to
customize the repeater parameters (such as, operating frequency,
PL, codes, and so on). Backup the codeplug data of the SLR 1000
Repeater using the RM application.
The repeater connection to facilitate the RM configuration is the USB
Type-B host connection located on the bottom side of the repeater.
Some repeater components can become extremely
hot during operation. Turn off all power to the
repeater and wait until it is sufficiently cool before
touching the repeater.



!


Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Exhibit D2 13 of 14