Brukerveiledning

9
English
NOTE: Follow all applicable electrical codes for the end use
country and locality.
Connections
Figure 9 illustrates the position of the connectors located on the
repeater. Table 1 identifies the connector types as well as the primary
function of the connector.
Table 1: Connector Type and Primary Function
NO Connector Function(s)
1 Transmitter RF (Tx) Output Board
Connection
2 Pressure Equalizer Vent
3 Receiver RF (Rx) Input Board
Connection
4N-Type –
Female
Transmitter RF (Tx) Output Cable
Port
5 Jumper Connection to enable
external on/off function
6 M6 TORX Screw Bonding Ground Connection
7 2.1 X 5.5 OD
Barrel Connector
DC Power Inlet
8 Header Connection for optional
antenna switch
9 RJ-45 – Aux/
Accessory
Rx Audio, Tx Audio, PTT, 1 PPS,
and GPIO
10 RJ-45 – Ethernet Network
11 Type B USB
Socket
Programming Interface
12 Option
Dependent
Option Dependent 1 and 2
13 Expansion Board Connection
(future use)
14 N-Type –
Female
Receiver RF (Rx) Input Cable Port
15 Front Panel Flex Connector
Table 1: Connector Type and Primary Function
Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Exhibit D2 11 of 14