Brukerveiledning

English
8
English
4. Insert the four M6 screws, supplied in the repeater package, into
the repeater chassis side fins and partially tighten. See Figure 2.
5. Place the repeater chassis into the bracket by sliding the M6
screws into the receiving slots on the bracket. Torque to 60 in-lb.
See Figure 3.
All connections to power are at the bottom of the repeater.
Terminated cables are passed through the cable openings with the
connectors added (system only), and then connected to the
connector on the repeater. The sealing cap is then tightened to
complete the seal.
Power Input Requirements
After the repeater equipment has been mechanically installed,
electrical connections must be made. This involves making the
following connections to:
• When applicable, AC input power cabling: 100–240 Volts
(47–63 Hz) at 1 A maximum.
• When applicable, DC input power cabling: 10.8 VDC to 15.6 VDC
at 4 A maximum.
Note: AC power supply accessories must be ordered separately .
Grounding
Connect a bonding wire from the repeater ground screw to the site
ground point. The size of the bonding wire used for this connection
must be 6 AWG minimum.
Figure 7: Wall Mount Bracket Attached to Pole Mount Bracket
The base station/repeater is to be connected to a battery
supply that is in accordance with the applicable electrical
codes for the end use country; for example, the National
Electric Code ANSI/NFPA No.70 for the U.S.
Ensure that the appropriate voltage is connected with a
nominal 13.6 VDC (11–14.4 VDC).
Refer to Motorola Quality Standards Fixed Network
Equipment Installation manual, R56 for complete
information regarding lightning protection.

!
W A R N I N G

!
Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Exhibit D2 10 of 14