Brukerveiledning
Table Of Contents
- Exhibit D - Tune-Up Procedure-User Manual-front
- Pages from MN003557A01-AL_enus_SLR1000_Repeater_Basic_Service_and_Installation_Manual_NAG
- Pages from Exhibit D - Tune-Up Procedure-User Manual-d2header
- MN003581A01_AA_enus_MOTOTRBO_SLR_1000_Repeater_Quick_Start_Guide-modified
English
4
English
Refer to product specific manuals for detailed safety and installation
instructions. Manuals can be obtained with product orders,
downloaded from https://businessonline.motorolasolutions.com or
purchased through the Motorola Aftermarket & Accessory
Department.
This is a class A product. In a domestic environment, this product
may cause radio interference in which case the user may be required
to take adequate measures.
MOTOTRBO SLR 1000 Repeater
Supplemental Safety and Installation
Requirements
ATTENTION!
The MOTOTRBO SLR 1000 Repeater can be installed in a suitable
in-building location, or suitable outdoor location. A restricted access
location is required when installing this equipment into the end
system.
When installing the equipment, all requirements of relevant standards
and local electrical codes must be fulfilled.
The maximum operating ambient temperature of this equipment is
60 °C, at sea level. Operating altitudes up to 5000 meters above sea
level are supported, but maximum operating temperature shall
degrade by 1°C /1000 m elevation. Operation above 5000 may be
feasible but operating specifications, and parameters are not
guaranteed and reduced performance may result.
General Installation
Proper installation ensures the best possible performance and
reliability of the repeater equipment. Pre-installation planning is
required. This includes considering the mounting location of the
equipment in relation to input power, antennas, and system
interfaces. Also to be considered are site environment conditions, the
particular mounting method (several available), and the required tools
and equipment.
If this is the first time installing this type of equipment, it is highly
recommended that the user read the following:
• Chapter 10 of the SLR 1000 Repeater Basic Service and
Installation Manual before beginning the actual installation.
Pre-Installation Overview
The following information is an overview for installing the SLR 1000
Repeater:
List of Supplied Items
• SLR 1000 Repeater
• Mounting hardware
• Quick Start Guide
NOTE: Save the repeater shipping container and its components
to facilitate possible future repeater shipping needs.
Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Exhibit D2 6 of 14