Brukerveiledning
Table Of Contents
- Exhibit D - Tune-Up Procedure-User Manual-front
- Pages from MN003557A01-AL_enus_SLR1000_Repeater_Basic_Service_and_Installation_Manual_NAG
- Pages from Exhibit D - Tune-Up Procedure-User Manual-d2header
- MN003581A01_AA_enus_MOTOTRBO_SLR_1000_Repeater_Quick_Start_Guide-modified
Figure 27: Rejection of Each Port for UHF Duplexer
5 Complete the tuning procedure, as follows:
a If the results are similar to Figure 27: Rejection of Each Port for UHF Duplexer on page 74
with better than -65 dB isolation between the LOW and HIGH ports of the duplexer, carefully
tighten the nuts on the six T10 torque screws.
Tighten them slightly snug, not all the way. Be careful not to accidentally change the tuning of
those screws.
b Observe the tuning so that the two DIPs are deeper than -65 dB. If so, continue to tighten the
tuning nuts.
The duplexer is now tuned.
MN003557A01-AL
Chapter 8 : SLR 1000 Programming and Tuning
74
Applicant: Motorola Solutions
Equipment Type: ABZ99FT3096B / 109AB-99FT3096B
Tune-Up Procedure
Exhibit D1 11 of 11