User's Manual

12
2. Short-press SB3 twice to begin to scan for device(s).
Double SCAN tone sounds every two seconds.
Note: To stop scan, short-press SB3 twice.
3. Turn Bluetooth device(s) on.
4. Place Bluetooth device(s) within 3 in. (7 cm.) of the
front of the radio. This must be done within a few
seconds of pressing SB3 twice.
Connection occurs with first Bluetooth device.
CONNECT tone sounds and tracking number
appears on display radio model.
If you are not connecting to a second device, short-
press SB3 twice to stop scan.
If you are connecting to a second device, keep all
devices within 3 in. (7 cm.) of each other until
CONNECT tone sounds again. Tracking number
appears on display radio models.
5. Operate devices.
You can now move devices outside the 3-in. (7-cm.)
connection range once connected.
Note: If connection occurs with only a Bluetooth Push-
To-Talk device, the connection will be dropped because
this device will not operate by itself.
Note: If connection does not occur, restart connection
(start at Step 2, above).
Turning Radio Off
Turn the radio’s Volume/On/Off knob until it clicks.