User's Manual

11
Single SCAN tone sounds every two seconds.
Note: To stop scan, short-press SB3 twice, and then
short-press SB3 twice again.
2. Turn Bluetooth device(s) on.
3. Place Bluetooth device(s) within 3 ft. (1 m.) of the
front of the radio. This must be done within a few
seconds of turning on the radio.
Connection occurs with Bluetooth audio device.
CONNECT tone sounds and tracking number
appears on display radio model.
If you were not previously connected to a Bluetooth
Push-To-Talk device, go to Step 4.
If you were previously connected to a Bluetooth
Push-To-Talk device, connection occurs. CONNECT
tone sounds again and tracking number appears on
display radio model.
4. Operate devices.
Note: If reconnection does not occur, turn radio off and
return to Step 1. If you are attempting to connect to a
different device, start at Step 2 in “Connecting to
Different Device(s)”, below.
Connecting to Different Device(s)
You can connect your Bluetooth radio to a different
Bluetooth device(s).
1. If you are in a connection, short-press SB3 twice to
disconnect. If not in a connection, go to Step 2.
ALERT tone sounds for each device disconnected.