User's Manual

8
Note: If connection does not occur, restart connection
(start at Step 2 in “Connecting to Different Device(s)” on
page 11) and make sure you are on an option board–
enabled channel (see “Channel Change” on page 10).
Verifying Connection
You can verify the connection between the Bluetooth
radio and Bluetooth device after a connection is made.
1. Short-press SB3 on radio.
2. Within two seconds of SB3 press, press and hold
PTT button on Bluetooth device.
You are connected if:
• VERIFY tone sounds on the radio.
• Tracking number appears on display.
3. Release PTT on Bluetooth device to exit verification.
Note: If this does not occur, try again, making sure to
short-press SB3 on radio first, before pressing PTT on
Bluetooth device, and making sure to press PTT within
two seconds of SB3 press. If there is still no VERIFY
tone or tracking number, the radio is not connected with
the Bluetooth device. See “Connecting to Different
Device(s)” on page 11 to restart connection.
Receiving a Call
When a call is received, you hear receive audio on
Bluetooth audio device.
Note: Use volume control on Bluetooth device to adjust
volume. You cannot adjust with Volume/On/Off knob on
Bluetooth radio.