User's Manual
Table Of Contents
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Declaration of Conformity
- Table of Contents
- List of Figures
- Related Publications
- Repeater Model Numbering Scheme
- Commercial Warranty
- Chapter 1 Pre-Installation Considerations
- Chapter 2 Mechanical Installation
- Chapter 3 Indicators and Connectors
- Chapter 4 Electrical Connections
- Chapter 5 Post-Installation Checklist
- Chapter 6 Accessories
- Appendix A Replacement Parts Ordering
- Appendix B Motorola Service Centers
6816814H01 December 2009
Indicators and Connectors Rear Panel 3-3
3.2.2 Rear Accessory Connector
The rear accessory connector is located above the ethernet connector. Most of the Motorola-
approved accessories are supplied with female terminals crimped to a 20-gauge wire specifically
designed to fit the housing of the rear accessory connector.
Insert the female terminal into the accessory connector housing in the appropriate locations. The
accessory connector housing is provided together with the accessory. Connect the accessory
connector housing to the rear accessory connector on the back of the repeater. Do not use other
generic terminals in the housing. Generic terminals can cause electrical intermittences and may
cause damage to the housing.
3.2.3 Ethernet Connector
The Ethernet connector supports both 10-Base-T and 100-Base-Tx connections. There are two
integrated LEDs (only supported on XPR 8380) in the connector:
Status Description
Green LED Indicates 100 Mbits speed when lit, and 10 Mbits speed when OFF.
Yellow LED Indicates a valid link when lit solid, and transmit/receive activity when
blinking.