User's Manual
Table Of Contents
- Declaration of Conformity
- Notes
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Scan Lists
- Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Dual-Tone Multi Frequency (DTMF)
- Trunking System Controls
- Utilities
- Locking and Unlocking the Keypad
- Turning Keypad Tones On or Off
- Setting the Squelch Level
- Controlling the Display Backlight
- Turning the Radio Tones/Alerts On or Off
- Turning the Talk Permit Tone On or Off
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Accessing General Radio Information
- Batteries and Chargers Warranty
- Limited Warranty
Advanced Features
English
41
Going Out of Range
When your radio goes out of the range of the system, it can no
longer lock onto a control channel.
Procedure:
1 A low-pitched tone sounds.
AND/OR
The display shows the currently selected channel
combination and Out of Range.
2 Your radio remains in this out-of-range condition until:
It locks onto a control channel.
OR
It locks onto a failsoft channel.
OR
It is turned off.
Using the Site Trunking Feature
If the zone controller loses communication with any site, that
site reverts to site trunking.
The display shows the currently selected channel combination
and Site Trunking.
NOTE: When this occurs, you can communicate only with
other radios within your trunking site.
Locking and Unlocking a Site
This feature allows your radio to lock onto a specific site and not
roam among wide-area talkgroup sites. This feature should be
used with caution, since it inhibits roaming to another site in a
wide-area system.
Procedure:
Use the preprogrammed Site Lock/Unlock button to toggle the
lock state between locked and unlocked.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Utilities and press N to select.
3 Por Q to Radio Settings and press N to select.
4 Por Q to Site Lock and press N to select.
5 You see Turn On if the site is currently in unlocked state.
OR
You see Turn Off if the site is currently in locked state.
6 Press N to select.
7 The display shows Site Locked.
OR
The display shows Site Unlocked.