User's Manual
Table Of Contents
- Declaration of Conformity
- Notes
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Scan Lists
- Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Dual-Tone Multi Frequency (DTMF)
- Trunking System Controls
- Utilities
- Locking and Unlocking the Keypad
- Turning Keypad Tones On or Off
- Setting the Squelch Level
- Controlling the Display Backlight
- Turning the Radio Tones/Alerts On or Off
- Turning the Talk Permit Tone On or Off
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Accessing General Radio Information
- Batteries and Chargers Warranty
- Limited Warranty
Advanced Features
English
28
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or noise
(termed a “nuisance” channel), you can temporarily remove the
unwanted channel from the scan list.
This capability does not apply to the channel designated as the
Selected Channel.
Procedure:
1 When your radio “locks on to” an unwanted or nuisance
channel, press the programmed Nuisance Delete button
until you hear a tone.
2 Release the Nuisance Delete button. The nuisance
channel is deleted.
Deleting a “nuisance” channel is only possible through the
programmed Nuisance Delete button. This feature is not
accessible through the menu.
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, do ONE of the
following:
• Turn the radio off and then powering it on again, OR
• Stop and restart a scan via the programmed Scan button or
menu, OR
• Change the channel via the Channel Selector Knob.