User's Manual
Table Of Contents
- Declaration of Conformity
- Notes
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Scan Lists
- Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Dual-Tone Multi Frequency (DTMF)
- Trunking System Controls
- Utilities
- Locking and Unlocking the Keypad
- Turning Keypad Tones On or Off
- Setting the Squelch Level
- Controlling the Display Backlight
- Turning the Radio Tones/Alerts On or Off
- Turning the Talk Permit Tone On or Off
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Accessing General Radio Information
- Batteries and Chargers Warranty
- Limited Warranty
Advanced Features
English
27
Starting and Stopping Scan
Procedure:
Press the programmed Scan button to start or stop Scan.
OR
Follow the procedure below.
1 Use the Channel Selector Knob to select a channel
programmed with a scan list.
2 S to access the menu.
3 Por Q to Scan and press N to select.
4 The display shows Turn On if scan is disabled.
OR
The display shows Turn Off if scan is enabled.
5 Press N to select.
6 The LED blinks yellow and the scan icon is displayed when
Scan is enabled.
OR
The LED turns off and the scan icon is not displayed when
Scan is disabled.
Responding to a Transmission During a Scan
During scanning, your radio stops on a channel/group where
activity is detected. The radio stays on that channel for a
programmed time period known as “hang time”.
Procedure:
1 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
2 Press the PTT button during hang time. The LED lights up
solid green.
3 Wait for the Talk Permit Tone to finish (if enabled) and speak
clearly into the microphone.
4 Release the PTT button to listen.
5 If you do not respond within the hang time, the radio returns
to scanning other channels/groups.