User's Manual
Table Of Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Notes
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Scan Lists
- Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Dual-Tone Multi Frequency (DTMF)
- Trunking System Controls
- Utilities
- Locking and Unlocking the Keypad
- Turning Keypad Tones On or Off
- Setting the Squelch Level
- Setting the Power Level
- Controlling the Display Backlight
- Turning the Radio Tones/Alerts On or Off
- Turning the Talk Permit Tone On or Off
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Accessing General Radio Information
- Accessories
- Batteries and Chargers Warranty
- Limited Warranty
Advanced Features
English
41
Using the Site Trunking Feature
If the zone controller loses communication with any site, that
site reverts to site trunking.
The display shows the currently selected channel combination
and Site Trunking.
NOTE: When this occurs, you can communicate only with
other radios within your trunking site.
Locking and Unlocking a Site
This feature allows your radio to lock onto a specific site and not
roam among wide-area talkgroup sites. This feature should be
used with caution, since it inhibits roaming to another site in a
wide-area system.
Procedure:
Use the preprogrammed Site Lock/Unlock button to toggle the
lock state between locked and unlocked.
OR
Follow the procedure below.
1 S to access the menu.
2 Por Q to Utilities and press N to select.
3 Por Q to Radio Settings and press N to select.
4 Por Q to Site Lock and press N to select.
5 You see Turn On if the site is currently in unlocked state.
OR
You see Turn Off if the site is currently in locked state.
6 Press N to select.
7 The display shows Site Locked.
OR
The display shows Site Unlocked.
8 The radio saves the new site lock state and returns to the
Home screen.
Viewing and Changing a Site
This feature allows you to view the number of the current site or
force your radio to change to a new one.
Viewing and Changing a Site
Procedure:
1 Press the preprogrammed Site Display button (it could be
short press or long press based on the configuration of the
programmable button).
2 The display momentarily shows the name of the current site
and its corresponding received signal strength indicator
(RSSI).
NAG_LACR.book Page 41 Monday, August 23, 2010 1:03 PM