User's Manual

Advanced Features

English

When your radio receives an Emergency Alarm, it displays the

Emergency Alarm received indications for approximately, 10

seconds.

Receiving an Emergency Alarm with Call

Procedure:

1 When receiving an Emergency Alarm with Call, the first line

of the display shows the alias or ID of the sender. The

second line displays Alarm Rcvd.

2 A tone sounds and the red LED blinks.

3 Press any button (except for backlight and volume) to clear

the alarm indication.

If no button is pressed, the alarm indication exits

automatically after a short duration.

4 You hear a voice from the Emergency Alarm with Call.

5 Press PTT button to initiate a call with the emergency

initiating radio. The green LED lights up.

6 Wait for the Talk Permit Tone to finish (if enabled) and

speak clearly into the microphone.

7 Release the PTT button to listen. When the emergency

initiating radio responds, the green LED blinks.

Sending an Emergency Call

This feature gives your radio priority access on a channel.

NOTE: The radio operates in the normal dispatch manner

while in Emergency Call, except, if enabled, it returns

to one of the following:

• Tactical/Non-Revert – You talk on the channel you

selected before you entered the emergency state.

• Non-Tactical/Revert – You talk on a programmed

emergency channel. The emergency alarm is sent

on this same channel.

Procedure:

1 Press the programmed Emergency button or the

Emergency footswitch.

2 The display shows Emergency, which alternates with your

radio ID. The green LED lights up and the Emergency icon

appears on the Home screen display.

The display shows No Emergency, if the selected channel

does not support emergency. Select a channel that shows

Emergency.

3 Press and hold the PTT button. Speak clearly into the

microphone.

4 Release the PTT button to end the transmission and wait for

a response from the dispatcher.

