User's Manual Part 2
Table Of Contents
- Scan
- Talkback
- PassPort Primary Auto Group Scan (PassPort Trunked Operation Only)
- PassPort Group Scan (PassPort Trunked Operation Only)
- Auto Group Scan (LTR Trunked Operation Only)
- All Group Scan (LTR Trunked Operation Only)
- System Scan (LTR Trunked and Conventional Operation Only)
- Deleting a Nuisance Channel/ Talkgroup (PassPort Group Scan or System Scan Operation Only)
- Editing a Scan List (PassPort Group Scan or System Scan Operation Only)
- Adding or Deleting Talkgroups or Channels in a Scan List
- Prioritizing a Talkgroup or Channel in a Scan List (System Scan Operation Only)
- Phone
- Voice Storage
- Audio/Tone Settings
- Utilities
- Warranty
- Quick Reference Card
65
English
SCAN
SYSTEM SCAN G
(LTR TRUNKED AND CONVENTIONAL
OPERATION ONLY
)
System Scan scans trunked talkgroups and
conventional channels between LTR and
conventional zones, as programmed by your
dealer. Up to 16 different talkgroups or
conventional channels can be programmed
into each Scan list. You can edit these lists
through your radio’s menu (see page 66).
When System Scan is Enabled
• The G symbol appears on the display.
• The LED indicator blinks green during Sys-
tem Scan operation; it stops blinking when
the radio switches to an active talkgroup or
channel.
Note: If you enter menu mode while the radio is
scanning, scanning stops. It resumes when
you exit menu mode.
To Start or Stop a System Scan Operation
Press the preprogrammed Scan button (see
page 20) to start or stop scanning,
–or–
Do the following:
1 ) to enter menu mode.
2 y or z until
3 ) to select
You see the current scan status.
4 y or z until
–or–
5 ) to confirm your selection.
Note: In conventional zones only, if there is
activity on a non-priority channel, the
radio disconnects the user from the
current conversation and automati-
cally switches to an active priority
channel. This is indicated with a
short alert tone.
System Scan
System Scan
Sys Scan On?
Sys Scan Off?