User's Manual Part 1
Table Of Contents
- Table of Contents
- Computer Software Copyrights
- Introduction
- Radio Overview
- Getting Started
- Turning the Radio On or Off
- Adjusting the Volume
- Selecting a Trunked Zone and Talkgroup
- Sending a Trunked Call
- Selecting a Conventional Zone and Channel
- Direct Zone Access
- Direct Channel Access
- Sending a Conventional Call
- Receiving a Trunked or Conventional Call
- Repeater or Talkaround Mode (Conventional Operation Only)
- Call Light (Trunked Operation Only)
- Home Channel
- Horn and Lights
- Remote Monitor (LTR Trunked and Conventional Operation Only)
- Passport Trunking
- Radio Calls
- Making a Selective Call (LTR Trunked and Conventional Operation Only)
- Receiving a Selective Call (LTR Trunked and Conventional Operation Only)
- Sending a Call Alert Page (LTR Trunked and Conventional Operation Only)
- Receiving a Call Alert Page (LTR Trunked and Conventional Operation Only)
- Radio Check (LTR Trunked and Conventional Operation Only)
- Sending a Status (Conventional Operation Only)
- Sending a Message (Conventional Operation Only)
- Receiving a Message (Conventional Operation Only)
- Responding to Emergency Alerts (Conventional Operation Only)
- Clearing an Emergency Alert (Conventional Operation Only)
- Sending an Emergency Remote Monitor (Conventional Operation Only)
- Sending an Emergency Alert (Conventional Operation Only)
- Sending a Remote Monitor
- Selective Radio Inhibit (Conventional Operation Only)
- Editing a Radio Call List (LTR Trunked and Conventional Operation Only)
- Name and Call Tone Tagging (LTR Trunked and Conventional Operation Only)
48
English
RADIO CALLS
RADIO CHECK
(LTR TRUNKED AND CONVENTIONAL
OPERATION ONLY)
Radio Check allows you to determine if a radio
is within the range of the trunked system and
turned on, without disturbing the user of that
radio. This feature can also be used when
attempts with Selective Call and Call Alert fail.
To Perform a Radio Check
SENDING A STATUS
(CONVENTIONAL OPERATION ONLY)
This feature gives you the ability to send a
status update to the base. The status feature
makes more efficient use of the channel
compared to voice transmissions. Status
updates of up to 14 characters may be
programmed by your dealer.
1 ) to enter menu mode.
2 y or z unt il
3 ) to select
4 y or z until
5 ) to select
6 y or z to locate the desired ID in
the Radio Call list
–or–
Enter the ID number of the radio you are
checking.
Radio Call
Radio Call
Radio Check
Radio Check
7 Press the PTT button,
you see:
8 If the Radio Check is received by the tar-
get radio, you see:
If not received, you see:
9 ( to return to
–or–
Hold down ( to exit menu mode.
Call In Prog
Acknowledge
No Acknowledge
Radio Call