User's Manual Part 1
Table Of Contents
- Table of Contents
- Computer Software Copyrights
- Introduction
- Radio Overview
- Getting Started
- Turning the Radio On or Off
- Adjusting the Volume
- Selecting a Trunked Zone and Talkgroup
- Sending a Trunked Call
- Selecting a Conventional Zone and Channel
- Direct Zone Access
- Direct Channel Access
- Sending a Conventional Call
- Receiving a Trunked or Conventional Call
- Repeater or Talkaround Mode (Conventional Operation Only)
- Call Light (Trunked Operation Only)
- Home Channel
- Horn and Lights
- Remote Monitor (LTR Trunked and Conventional Operation Only)
- Passport Trunking
- Radio Calls
- Making a Selective Call (LTR Trunked and Conventional Operation Only)
- Receiving a Selective Call (LTR Trunked and Conventional Operation Only)
- Sending a Call Alert Page (LTR Trunked and Conventional Operation Only)
- Receiving a Call Alert Page (LTR Trunked and Conventional Operation Only)
- Radio Check (LTR Trunked and Conventional Operation Only)
- Sending a Status (Conventional Operation Only)
- Sending a Message (Conventional Operation Only)
- Receiving a Message (Conventional Operation Only)
- Responding to Emergency Alerts (Conventional Operation Only)
- Clearing an Emergency Alert (Conventional Operation Only)
- Sending an Emergency Remote Monitor (Conventional Operation Only)
- Sending an Emergency Alert (Conventional Operation Only)
- Sending a Remote Monitor
- Selective Radio Inhibit (Conventional Operation Only)
- Editing a Radio Call List (LTR Trunked and Conventional Operation Only)
- Name and Call Tone Tagging (LTR Trunked and Conventional Operation Only)
29
English
GETTING STARTED
GETTING STARTED
TURNING THE RADIO ON OR OFF
ADJUSTING THE VOLUME
Turn the On/Off/Volume Control knob
clockwise to increase the volume, or
counterclockwise to decrease the volume.
–or–
ON OFF
Push the On/Off/
Volume Control knob.
If power-up is
successful, you hear
the Self-Test Pass Tone
and see the LED
momentarily turn
green.
If the radio fails to
power up, you hear the
Self-Test Fail
Tone .
Push the On/Off/
Volume Control knob
until you hear a click and
the display clears.
1 Hold down the Volume Set button (see
page 26). You hear a continuous tone.
2 Tur n the On/Off/Volume Control knob to
the desired volume level.
3 Release the Volume Set button.
Control Knob
On/Off/Volume
04_GetStarted.fm Page 29 Tuesday, April 2, 2002 4:38 PM