User's Manual

Description Quantity
SLR 1000 Repeater 1
Serrated Hex Flange M3 Screws 4
10.2.2
Mounting the SLR 1000 Repeater to a Wall or Ceiling
Perform this procedure to mount the SLR 1000 Repeater to either a wall or to a ceiling.
NOTICE: A wall mount provides a vertical fin orientation. This orientation is required for high
temperatures and maximum performance.
Prerequisites: Obtain the following:
•
Contents of the repeater package. See SLR 1000 Repeater Package Contents on page 82.
• Four #10/32 lag bolts (not included in the repeater package).
• Torque wrench, adjustable wrench, or a ratchet with a 10mm socket
Procedure:
1 Attached the bracket to either the wall or ceiling using four #10/32 lag bolts. See Figure 31:
Bracket Mounting Holes on page 83.
Figure 31: Bracket Mounting Holes
2 Insert the four M6 screws into the repeater chassis side fins and partially tighten. See Figure 32:
Location of Repeater M6 Screw Mounts on page 83.
Figure 32: Location of Repeater M6 Screw Mounts
3 Place the repeater chassis into the bracket by sliding the M6 screws into the receiving slots on
the bracket. Torque to 60 in-lb. See Figure 33: Bracket Receiving Slots on page 83.
Figure 33: Bracket Receiving Slots
10.2.3
Mounting the SLR 1000 Repeater to a Pole
Perform this procedure to mount the SLR 1000 Repeater to a pole.
Prerequisites: Obtain the following:
• Pole Mount Kit. Consists of:
- One pole mount bracket
- One ½ in. U-bolt
- Two ½ in. bolts
- Four ½ in. nuts
• Torque wrench, adjustable wrench, or a ratchet with a 10mm socket
When and where to use:
There are two possible options for the pole mount installation:
1 Using a U-bolt with four ½ in. nuts for poles with a diameter between 2 – 3.5 in.
MN003557A01-AA
Chapter 10: SLR 1000 Installation
Send Feedback 83
Preliminary FCC Filing