User's Manual

e Remove the Tx cable by either cutting the cable from the Tx input port or tie wrapping the
cable.
CAUTION: The Tx cable must not touch any components on the board.
Figure 27: SLR 1000 Repeater Front View (without top cover)
Table 22: SLR 1000 Repeater Front View (without top Cover) Callout Legend
Label Description
1 Transmitter RF (Tx) Output
2 Receiver RF (Rx) Output
3 Transmitter RF (Tx) Input
4 Receiver RF (Rx) Input
5 Front Panel Flex Connector
4 Install the duplexer into the repeater, as follows:
a Lay the front panel flex cable down across the board.
b Place the duplexer into the chassis and align the screw openings, as shown in Figure 28:
SLR 1000 Repeater Front View (without top cover) with a Duplexer
on page 74
c Insert the duplexer antenna port through the Rx input opening in the chassis.
d Reinstall the lockwasher and nut onto the antenna port. Torque to 20 in./lbs.
e Insert the low passport cable into the Tx output port.
f Place the high passport cable underneath the duplexer and insert into the Rx output port.
g Secure the duplexer to the chassis with the four M3 screws using a T10 bit. Torque to 10 in./
lbs.
h Reattach the front panel flex cable to the front panel display board, making sure not to bend
the cable.
The cable stops at the black line.
i Place the top cover back onto the chassis, making sure not to pinch any cables.
j Hold the cover onto the chassis and carefully turn the repeater over.
k Reinstall the four M4 screws using a T10 bit. Torque to 20 in./lbs.
5 Restore power to the repeater.
Figure 28: SLR 1000 Repeater Front View (without top cover) with a Duplexer
Table 23: SLR 1000 Repeater Front View (without top Cover) with a Duplexer Callout Legend
Label Description
1 Transmitter RF (Tx) Output
2 Duplexer
3 Receiver RF (Rx) Output
4 Transmitter RF (Tx) Input
5 Receiver RF (Rx) Input
Table continued…
MN003557A01-AA
Chapter 9: SLR 1000 Maintenance and Disassembly/Reassembly
74 Send Feedback
Preliminary FCC Filing