User's Manual

• Signal ground is Pin 4 of the Aux connector.
5 Key up the repeater and measure the deviation
•
Key the repeater by grounding Pin 2 of the Aux connector.
NOTICE: RM must have Pin 2 configured as an active low with the PTT function.
6 De-key the repeater.
The deviation shall meet the limits shown in the following table.
Channel Spacing
(kHz)
Relative Standard Deviation (RSD)
(kHz)
92% of RS
(kHz)
Tolerance
(Hz)
12.5 2.5 2.3 +0/-50
20.0 4.0 3.68 +0/-80
25.0 5.0 4.6 +0/-100
NOTICE:
•
The repeater is factory-tuned in accordance to this procedure and specification.
• Verification is performed outside of the Tuner application, such as in normal mode.
MN003557A01-AA
Chapter
8: SLR 1000 Programming and Tuning
70 Send Feedback
Preliminary FCC Filing