User's Manual

5.2.1
DC Power Inlet
The DC power inlet connector is a 2.1 X 5.5 Barrel type coaxial power connector receptacle panel.
Figure 13: DC Power Inlet Connector
on page 54 shows the location of the pins and Table 15: DC
Power Inlet Connector Callout Legend on page 54 lists the functional characteristics of the
connector’s pins.
Figure 13: DC Power Inlet Connector
Table 15: DC Power Inlet Connector Callout Legend
Location Type Signal Characteristics
Inner 12 V 10.8 – 15.6 VDC
4 A (max)
Outer Ground
5.2.2
USB
Type B socket (Device Connection) that supports the USB 2.1 protocol standard. Figure 14: USB
Connector
on page 54 shows the location of the pins and Table 16: USB Connector Callout Legend
on page 54 lists the functional characteristics of the connector’s pins.
Figure 14: USB Connector
Table 16: USB Connector Callout Legend
Location Pin Assignment Type Signal Characteristics
1 VBUS
USB Physical
Layer
+5 VDC
2 D- 3.6 V differential data
3 D+
4 GND Ground
5.2.3
Ethernet
Fully compliant with IEEE and 802.3 and 802.3u standards. Supports 10Base-T, 100Base-Tx rates, full
duplex, half duplex mode and flow control. Figure 15: Ethernet Connector
on page 54 shows the
location of the pins and
Table 17: Ethernet Connector Callout Legend on page 54 lists the functional characteristics of the
connector’s pins.
Figure 15: Ethernet Connector
Table 17: Ethernet Connector Callout Legend
Location Pin Assignment Type Signal Characteristics
1 Ethernet Tx+
Ethernet
Physical Layer
5 V differential data
2 Ethernet Tx-
3 Ethernet Rx+
4 Unused N/A
Table continued…
MN003557A01-AA
Chapter 5: SLR 1000 Bottom Panel
54 Send Feedback
Preliminary FCC Filing