User's Manual

Chapter 5
SLR 1000 Bottom Panel
5.1
Description
The Bottom Panel interface provides the electrical interconnection interface between the SLR 1000
Repeater and the end user’s system. This includes the connectors necessary to program/configure the
repeater, as well as interface the repeater to the power system, system controllers, LANs, and other
communications and maintenance equipment. This section provides a general description,
identification of inputs/ outputs and how the inputs are connected and sealed, and a pin-out listing for
all connectors, including information on signal names, functions, and levels.
5.1.1
General Description
Figure 12: SLR 1000 Repeater Bottom Panel Connector Names and Locations
on page 53 shows
the various interface connector locations. Table 14: SLR 1000 Repeater Connector Types and Primary
Functions on page 53 lists the connector types as well as its primary function.
Figure 12: SLR 1000 Repeater Bottom Panel Connector Names and Locations
Table 14: SLR 1000 Repeater Connector Types and Primary Functions
Location Connector Type Function(s)
1 N-Type – Fe-
male
Transmitter RF (Tx)
2 M6 TORX Screw Bonding Ground Connection
3 2.1 X 5.5 OD
Barrel Connector
DC Power Inlet
4 RJ-45 – Aux/
Accessory
Rx Audio, Tx Audio, PTT, 1 PPS, and GPIO
5 RJ-45 – Ethernet Network
6 Type B USB
Socket
Programming Interface
7 Option Depend-
ent
Option Dependent 1 and 2
8 N-Type – Fe-
male
Receiver RF (Rx)
5.2
Bottom Panel Interfaces
This section describes the different bottom panel interfaces that are available in the repeater.
MN003557A01-AA
SLR 1000 Bottom Panel
Send Feedback 53
Preliminary FCC Filing