User's Manual

Label Description
3 Receiver RF (Rx) Output
4 Transmitter RF (Tx) Input
5 Jumper Connection to enable external on/off function
6 Bonding Ground Connection
7 DC Power Inlet
8 Aux/Accessory Port
9 Ethernet Port
10 USB Port Programming Interface
11 Header Connection for optional antenna switch
12 Option Dependent 1 and 2
13 Expansion Board Connection (for future use)
14 Receiver RF (Rx) Input
15 Front Panel Flex Connector
1.3
Operating Features
The following are the standard features of an SLR 1000 Repeater model:
•
MOTOTRBO Conventional Operation (2-Slot TDMA, 4FSK Modulation)
• Analog Conventional Operation (FM)
• Continuous Duty Cycle Operation over -30 °C to +60 °C
• Meets or exceeds the following standards:
• TIA603D
• ETSI 086
• ETSI 113
• ETSI TS 102 361-1 Part 1: DMR Air Interface Protocol
• ETSI TS 102 361-2 Part 2: DMR Voice and Generic Services and Facilities
• ETSI TS 102 361-3 Part 3: DMR Packet Data Protocol
• ETSI TS 102 361-4 Part 4: DMR Trunking Protocol
• Synthesized Frequency Generation
• Female N-type Antenna Connector (Tx)
• Female N-type Antenna Connector (Rx)
• Ethernet Port (Network)
• USB Port (Service)
• 4 configurable GPIO ports (Digital)
• 1 configurable GPI ports (Analog)
• 1 configurable GPO ports (Analog)
• 1.5 PPM Frequency Stability (Temperature AND 1-Year Aging) (VHF and UHF)
• Station Diagnostic Tests – Fixed Set of Tests run upon Start-up
MN003557A01-AA
Chapter 1: SLR 1000 Repeater
Send Feedback 35
Preliminary FCC Filing