User's Manual

5
English
MOTOTRBO SLR 8000 Series Base Station
Repeater Supplemental Safety and
Installation Requirements
ATTENTION!
The MOTOTRBO SLR 8000 Series Base Station Repeater must be
installed in a suitable, in-building enclosure. A restricted access
location is required when installing this equipment into the end
system.
The Base Station Repeater contains a Class 1 built-in power supply
component. It is equipped with an appliance inlet for connecting to an
AC input, as well as DC input terminals which meet SELV DC circuit
requirements.
When installing the equipment, all requirements of relevant standards
and local electrical codes must be fulfilled.
The maximum operating ambient temperature of this equipment is
60°C. The maximum guaranteed operating altitude is 5000 meters
above sea level. Operating above this maximum altitude may result in
degradation to product specifications and compliances.
The nominal 15.75 VDC output from the power supply to the PA is at
an energy hazard level (exceeds 240 VA).
When installing into the end system, care must be taken so as not to
touch the output wires. When the MOTOTRBO SLR 8000 Series
Base Station Repeater is used in a DC reverting system, the DC
power supply must be located in the same building as the
MOTOTRBO SLR 8000 Series Base Station Repeater, and it must
meet the requirements of a SELV circuit.
General Installation
Proper installation ensures the best possible performance and
reliability of the Base Station Repeater equipment. Pre-installation
planning is required. This includes considering the mounting location
of the equipment in relation to input power, antennas, and system
interfaces. Also to be considered are site environment conditions, the
particular mounting method (several available), and the required tools
and equipment.
If this is the first time installing this type of equipment, it is highly
recommended that the user read the following:
• Chapter 12 of the SLR 8000 Series Basic Service and Installation
Manual before beginning the actual installation.
Pre-Installation Overview
The following information is an overview for installing the SLR 8000
Series Repeater:
List of Supplied Items
• SLR 8000 Series Base Station Repeater
• Cabinet and Rack mounting hardware
• AC line cord
• Quick Start Guide
NOTE: Save the SLR 8000 Series Base Station Repeater shipping
container and its components to facilitate possible future
SLR 8000 Series Base Station Repeater shipping needs.

SLR_8000_NAG.book Page 5 Tuesday, November 17, 2015 11:38 PM