User's Manual

English

General Safety and Installation Standards and Guidelines

The following are additional general safety precautions that must be observed:

• To continue compliance with any applicable regulations and maintain the safety of this equipment, do not install substitute parts or perform

any unauthorized modifications.

• All equipment must be serviced by Motorola trained personnel.

• If troubleshooting the equipment while the power is on, be aware of live circuits which could contain hazardous voltage.

• Do not operate the radio transmitters unless all RF connectors are secure and all connectors are properly terminated.

• All equipment must be properly grounded in accordance with the Motorola R56 and specified installation instructions for safe operation.

• Slots and openings in the cabinet are provided for ventilation. Do not block or cover openings that protect the devices from overheating.

• Some equipment components can become extremely hot during operation. Turn off all power to the equipment and wait until sufficiently

cool before touching.

• Maintain emergency first aid kits at the site.

• Never store combustible materials in or near equipment racks. The combination of combustible material, heat and electrical energy

increases the risk of a fire hazard.

• Equipment shall be installed in a site that meets the requirements of a “restricted access location,” per (UL60950-1 & EN60950-1), which is

defined as follows: “Access can only be gained by service persons or by users who have been instructed about the reasons for the

restrictions applied to the location and about any precautions that shall be taken; and access is through the use of a tool or lock and key, or

other means of security, and is controlled by the authority responsible for the location.”

• Burn hazard. The metal housing of the product may become extremely hot. Use caution when working around the equipment.

WARNING: For safe installation, operation, service and repair of this equipment, follow the safety precautions and

instructions described below, as well as any additional safety information in Motorola’s product service and installation

manuals and the Motorola R56 Standards and Guidelines for Communications Sites manual (which can be obtained by

ordering CD-ROM 9880384V83). To obtain copies of these materials, please contact Motorola as directed at the end of this

section. After installation, these instructions should be retained and readily available for any person operating or servicing this

Base Station Repeater or working near it.

Failure to follow these safety precautions and instructions could result in serious injury or property damage. The installation

process requires preparation and knowledge of the site before installation begins. Review installation procedures and

precautions in the Motorola R56 manual before performing any site or component installation. Personnel must use safe work

practices and good judgment, and always follow applicable safety procedures, such as requirements of the Occupational

Safety and Health Administration (OSHA), the National Electrical Code (NEC), and local codes.

W A R N I N G

SLR_8000_NAG.book Page 2 Tuesday, November 17, 2015 11:38 PM