User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
7.2.10
Receiver RF
The Receiver RF port is a BNC (female) type connector.
Figure 34: Receiver RF Connector
7.2.11
Transmitter RF
The Transmitter RF port is an N-Type (female) type connector. Figure 35: Transmitter RF Connector
on page 79 depicts the Transmitter RF connector.
Figure 35: Transmitter RF Connector
7.2.12
Bonding Ground Connection
The repeater Bonding Ground Connection is realized with an M6 x 1 x 3 mm screw (T30 Torx). Figure
36: Bonding Ground Connection on page 79 depicts the Bonding Ground Connection.
Figure 36: Bonding Ground Connection
MN001436A01-AD
Chapter 7: SLR 5000 Series Back Panel
Send Feedback 79