User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
7.2.7
Ethernet 2
Not supported at this time. Fully compliant with IEEE and 802.3 and 802.3u standards. Supports
10Base-T, 100Base-Tx rates, full duplex, half duplex mode and flow control. See Figure 31: Ethernet 2
Connector on page 75 and Table 31: Ethernet 2 Connector on page 75 for the location of the pins
and the functional characteristics of the connector's pins.
Figure 31: Ethernet 2 Connector
1
8
Table 31: Ethernet 2 Connector
Location Pin Assignment Type Signal Characteristics
1 Ethernet Tx+
Ethernet
Physical Layer
5 V differential data2 Ethernet Tx-
3 Ethernet Rx+
4 Unused N/A
5 Unused N/A
6 Ethernet Rx- 5 V differential data
7 Unused N/A
8 Unused N/A
7.2.8
Auxiliary (Aux)
This connection supports the analog interface to the SLR 5000 series repeater, which includes audio,
station control, station indicators, accessory power, and provisions for timing used in various system
implementations. See the following figure and table for location of the pins and the functional
characteristics of the connector's pins.
MN001436A01-AD
Chapter 7: SLR 5000 Series Back Panel
Send Feedback 75