User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
on page 73 shows the location of the pins and Table 28: DC Power Inlet/DC Charger Outlet
Connector on page 73 lists the functional characteristics of the connector's pins.
Figure 26: DC Power Inlet/DC Charger Outlet Connector
1
2
Table 28: DC Power Inlet/DC Charger Outlet Connector
Location Pin Assignment Type Signal Characteristics
1 Positive
Power
11–14.4VDC
17 A (max)
2 Negative
7.2.3
Option 1/GNSS
Not supported at this time (No connection)
Figure 27: Option 1/GNSS Connector
7.2.4
Option 2/WLAN
Not supported at this time (No connection)
Figure 28: Option 2/WLAN Connector
7.2.5
USB
Not supported at this time. Type A socket (Host Connection) that supports the USB 2.1 protocol
standard. See Figure 29: USB Connector on page 74 and Table 29: USB Connector on page 74
the location of the pins and the functional characteristics of the connector's pins.
MN001436A01-AD
Chapter 7: SLR 5000 Series Back Panel
Send Feedback 73