User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
Location Connector Type Function(s)
12 N-Type – Female Transmitter RF (Tx)
7.2
Back panel Interfaces
This section describes the back panel interfaces of the SLR 5000 Series Repeater.
7.2.1
AC Power Inlet
The AC power inlet connector is of the C14 type socket (IEC 60320) and accepts interface to C13 type
plugged (IEC 60320) power cords. Figure 24: AC Power Inlet Connector on page 72 shows the
location of the pins and Table 26: AC Power Inlet Connector on page 72 lists the functional
characteristics of the connector's pins.
Figure 24: AC Power Inlet Connector
1
2
3
Table 26: AC Power Inlet Connector
Location Pin Assignment Type Signal Characteristics
1 Earth
Power
100–240VAC (Line to Neutral)
4 A (max)
2 Line
3 Neutral
Figure 25: Repeater Power Switch
1
2
Table 27: Callout Legend
Label Description
1 ON (fully powered)
2 STANDBY
7.2.2
DC Power Inlet/DC Charger Outlet
The DC power inlet/DC charger outlet connector is a Molex 42818-02012 panel mount receptacle and
accepts interface to Molex 42816-0212 plugs. Figure 26: DC Power Inlet/DC Charger Outlet Connector
MN001436A01-AD
Chapter 7: SLR 5000 Series Back Panel
72 Send Feedback