User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
Chapter 6
SLR 5000 Series Front Panel
6.1
Description
The Front Panel Module is described in this section. A general description, identification of inputs and
outputs and functional theory of operation are provided. The information provided is sufficient to give
service personnel a functional understanding of the module, allowing maintenance and troubleshooting
to the module level.
6.1.1
General Description
The Front Panel board user interface includes seven LED indicators and a USB device port.
The board is connected to the modem via a 30 pin flex cable. The LED indicators inform the user of the
state of the repeater while the USB device port is used to interface with the repeater through the
Customer Programming Software (CPS). The LED indications are transferred to the front panel via a
serial peripheral interface.
6.2
Input and Output Connections
Figure 22: Front Panel Input and Output Connections on page 69 shows the various front panel Input
and Output connections.
Figure 22: Front Panel Input and Output Connections
1
3
2
4
5
Pin 1
Pin 30
Table 24: Callout Legend
Label Description
1 Modem Interface
2 LED Indicators
Table continued…
MN001436A01-AD
SLR 5000 Series Front Panel
Send Feedback 69