User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
Parameter Specifications
VHF UHF
UHF R2, 450–527 MHz
Minimum Input Return Loss (Tx mode) 15 dB
Rated RF Input Power 37 dBm
Maximum Standby Power Consumption 0.5 W
Rated RF Output Power Range 1–50 W
Supply Nominal Voltage
3
13.6 V (+/- 10%)
Maximum Current Draw
4
12.0 A
4.5
Modem Interface
The digital interface to the modem module utilizes a 20 pin vertical LIF connector. It’s location is shown
in Figure 15: Input and Output Connections on page 60. See Figure 16: Modem Interface Connector
Pin Locations on page 61 for front panel interface connector pin locations.
Figure 16: Modem Interface Connector Pin Locations
Pin 20 Pin 1
3
When the SLR 5000 series repeater is operating from a DC source, the PA input voltage follows
the repeater's DC input source.
4
Nominal VSWR conditions (VSWR <1.5:1)
MN001436A01-AD
Chapter 4: SLR 5000 Series Power Amplifier
Send Feedback 61