User's Manual

Notice
General Safety and Installation
Standards and Guidelines
WARNING:
• For safe installation, operation, service and repair of this equipment, follow the safety
precautions and instructions described below, as well as any additional safety information in
Motorola Solutions product service and installation manuals and the Motorola Solutions R56
Standards and Guidelines for Communications Sites manual (which can be obtained by
ordering CDROM 9880384V83). To obtain copies of these materials, please contact
Motorola Solutions as directed at the end of this section. After installation, these instructions
should be retained and readily available for any person operating or servicing this repeater
or working near it.
• Failure to follow these safety precautions and instructions could result in serious injury or
property damage.
• The installation process requires preparation and knowledge of the site before installation
begins. Review installation procedures and precautions in the Motorola Solutions R56
manual before performing any site or component installation. Personnel must use safe work
practices and good judgment, and always follow applicable safety procedures, such as
requirements of the Occupational Safety and Health Administration (OSHA), the National
Electrical Code (NEC), and local codes.
The following are additional general safety precautions that must be observed:
• To continue compliance with any applicable regulations and maintain the safety of this equipment,
do not install substitute parts or perform any unauthorized modifications.
• All equipment must be serviced by Motorola Solutions trained personnel.
• If troubleshooting the equipment while the power is on, be aware of live circuits which could contain
hazardous voltage.
• Do not operate the radio transmitters unless all RF connectors are secure and all connectors are
properly terminated.
• All equipment must be properly grounded in accordance with the Motorola Solutions R56 and
specified installation instructions for safe operation.
• Slots and openings in the cabinet are provided for ventilation. Do not block or cover openings that
protect the devices from overheating.
•
Some equipment components can become extremely hot during operation. Turn off all power
to the equipment and wait until sufficiently cool before touching.
• Maintain emergency first aid kits at the site.
• Never store combustible materials in or near equipment racks. The combination of combustible
material, heat and electrical energy increases the risk of a fire hazard.
Equipment shall be installed in a site that meets the requirements of a
"restricted access location", per (UL60950-1 & EN60950-1), which is defined as follows: "Access
can only be gained by service persons or by users who have been instructed about the reasons for
the restrictions applied to the location and about any precautions that shall be taken; and access is
MN001436A01-AD
General Safety and Installation
Standards and Guidelines
Send Feedback 5