User's Manual
Table Of Contents
- Foreword
- General Safety and Installation Standards and Guidelines
- MOTOTRBO SLR 5000 Series Repeater Supplemental Safety and Installation Requirements
- Environmental Information
- Document History
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Related Publications
- Summary of Bands Available
- Commercial Warranty
- SLR 5000 Series Repeater
- SLR 5000 Series Satellite Receiver
- SLR 5000 Series Modem
- SLR 5000 Series Power Amplifier
- SLR 5000 Series Power Supply
- SLR 5000 Series Front Panel
- SLR 5000 Series Back Panel
- SLR 5000 Series Test Equipment And Service Aids
- SLR 5000 Series Performance Check or Testing
- SLR 5000 Series Programming and Tuning
- SLR 5000 Series Maintenance and Disassembly/Reassembly
Figure 53: Removing Power Supply Module from Repeater
2 Remove the Power Supply Module from the repeater.
11.5.2.7
Modem Removal
Prerequisites:
NOTICE: Ensure all connections from Power Supply to various parts of the repeater have been
detached.
Procedure:
1 Detach the two coaxial cables connecting the RX Input and Reference (REF) Input connectors
to the Modem.
2 Remove the four screws holding the Modem to the repeater chassis with a T20 Torx driver.
Figure 54: Removing Modem
3 Remove the Modem from the repeater.
11.5.2.8
Power Amplifier Module Removal
Prerequisites:
NOTICE: Ensure all connections from Power Supply to various parts of the repeater have been
detached.
MN001436A01-AD
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Send Feedback 103